![]() ![]() ![]() *Note: you may need to check where your devices are mounted. emc-test-all.sh sda1 sdb1 sdc1 mmcblk0p1 Here are examples how to run the scripts (in this example /dev/mmcblk1p1 is a filesystem device): name-of-the-test.sh SATA_DIR USB0_DIR USB1_DIR MMC0_DIR" As script parameters use the directories where the devices are mapped (without /dev/) ". Run test scripts (they are included in the file system, or you can download them here: Download Standard Test or Download Heavy Test). Update the u-boot to boot up from SD card and set few other parameters: Insert the SD card to the edge SD card slot.ģ. Download this file system (created based on Jasbirs blog), download this kernel and follow these steps to prepare SD card.Ģ. No antennas connected, no SIM card inserted.ġ. Modem: inserted, but not actively used.Wifi PCIE mini card: inserted, but not actively used.Audio loopback: a cable connected between Line in and Line out.Headphones & Microphone: standard headphones connected to the headphones and microphone jack.SATA CFAST card (without the metal card holder): used for read/write testing.During the test, the cable was terminated with an RS232 to USB converter. 2x USB memory stick: each connected through an extension cable.HDMI monitor: during the test, the monitor is connected but turned off.Ethernet: Ethernet loopback cable connected.SD card 2 (the one under heatsink): used for read/write testing.SD card 1 (the one on the PCB edge): preloaded with Filesystem and used for booting.Power jack: +12V from an isolated source.Hardware configuration Connected cables/devices ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |